skip to content »

centr-geoteh.ru

Updating ios on 6506 sup720

updating ios on 6506 sup720-46

Can I use the same NFA to monitor both the Internet Router and the LAN Core Switches?Can you help me with the configuration procedures on our clustered Core Switches and if any in NFA?

updating ios on 6506 sup720-69

This is the only module that you have to download from cisco. The first image is 13MB, while the new image is 72MB. The two images are obviously for the Sup720, but is there another image I should be aware of or just sup engine? your 6500 routes as well as switches then you are running in hybrid mode. You can use the "" command to select which ROMMON will be the preferred ROMMON the next time that the system is booted.You can change the preference as often as you like, but keep in mind that the changes do not take effect until you reset the system.However I cannot get get to the boot command to point to bootdisk.

It only allows me to point to flash: )#boot system flash ?

This is the first time I have ever attempted to replace the IOS on a 6509 so I am taking this one slow."dir flash:" shows the following image: cat6000-sup720k8.8-1-3

The new image is: s72033-ipservicesk9_wan-mz.122-33.

mls flow ip interface-full mls nde interface Since you have Supervisor Engine 720, you need to execute the above two commands to put the interface information in the netflow packets.

ip flow ingress layer2-switched vlan The above two commands will help to enable Net Flow data export on PFC.

WORD System image filename Yet I don't seem to have an option to copy this new IOS to flash.