skip to content »

Xp wireless validating identity problem

xp wireless validating identity problem-86

I cannot get WPA2 enterprise to work on my network. Windows Domain, using IAS and its own CA Linksys WAP200 Access Point I setup the AP to use WPA2-Enterprise Mixed using RADIUS I setup and registered IAS on the domain controller.I added the AP as a client with and have tried using both RADIUS Standard and Cisco as the RADIUS type.

xp wireless validating identity problem-37xp wireless validating identity problem-52

By default, the wifi SSID will always be the model of the Cradlepoint router separated by a (-) and then the last 3 of the routers MAC address.First of all I tried to connect using the built-in wireless, even after updating the driver, no network is found. I then tried installing the supplied Sitecom N adapter, after some problems the network appears but I can't connect, I am told "Windows was unable to find a certificate to log you onto the network" I read several threads that led me to uncheck "Enable IEEE 802.1x authentication for this network" and I actually managed to enter the WPA2 code but this just leads to the message "This connection has limited or no connectivity" and "validating identity". It says something about windows not finding a certificate.The weird part is that I was using WPA TKIP with the passphrase and it was working fine.I recently set up a wireless network for my new Sitecom WL-585 modem router with WPA-2 security and all went according to plan.

I have a Win 7 laptop, Vista laptop, XP laptop, Nokia N95 and Soundbridge all connected.

WAN ports are usually colored blue and/or labeled with an icon that looks like a little monitor; they are intended to be used to connect devices that provide internet, such as Cable, DSL, or Satellite modems.

If you see a message about Validating Identity upon connecting to the Cradlepoint router, it means WEP security mode is enabled.

If you are trying to connect to the 5GHz wifi, there will be a 5g after the last 3 of the routers MAC address.

Note: If your router has multiple ethernet ports, DO NOT use the WAN port to connect a computer.

I tried to connect to the LAN using Ethernet (again after updating the driver), although I am apparently connected I can't reach the Internet and can't see what settings might need tweaking.